Disassembly

Occasionally, the weapon requires disassembly however, this should be done only when absolutely necessary, not for daily maintenance. An example of this would be to remove an obstruction that is stuck between the forestock and the barrel. When disassembly is required, the recommended procedure is as follows:

a. Point the rifle in a safe direction.

b. Put the safety in the "S" position.

c. Remove the bolt assembly.

d. Use the 1/2-inch combination wrench, loosen the front and rear mounting ring nuts (Figure 2-14) on the scope, and remove the scope.

e. Loosen the front and rear trigger guard screws (Figure 2-15).

f. Lift the stock assembly from the barrel assembly (Figure 2-16).

g. Reassemble in reverse order.

Disassemblaggio Sniper

WARNING

ALWAYS KEEP FINGERS AWAY FROM THE TRIGGER UNTIL READY TO FIRE, MAKE SURE THE RIFLE IS NOT LOADED BY INSPECTING THE MAGAZINE AND CHAMBER, USE AUTHORIZED AMMUNITION AND CHECK THE CONDITION BEFORE LOADING THE RIFLE.

Was this article helpful?

0 0

Post a comment